Find Brake Master Cylinder For Toyota Corolla/Matrix, Brake Master Cylinder For PONTIAC VIBE, 19205191 / 47201-02490 / 47201-02491 /47201-12B20 on Industry Directory, Reliable Manufacturer/Supplier/Factory from China.

Inquiry Basket (0)
Home > Products > Brake Master Cylinder > Brake Master Cylinder For Toyota Corolla / Matrix and PONTIAC VIBE AIBHI 19205191 / 47201-02490 / 47201-02491 / 47201-12B20 DIA

Brake Master Cylinder For Toyota Corolla / Matrix and PONTIAC VIBE AIBHI 19205191 / 47201-02490 / 47201-02491 / 47201-12B20 DIA

Basic Info

Model No.: BHI1210L-1

Product Description

DIA:22.22mm
Mounting Size:Φ52.5/100/35°/2-Φ9.2
Connetcing Size:M10 x 1.0

M10 x 1.0

OEM:

19205191
47201-02490
47201-02491
47201-12B20
DORMAN:M630660

Model:

2008-2011 TOYOTA Matrix
2009 TOYOTA Corolla
2010 PONTIAC VIBE 1.8L L4


REMOVING THE ORIGINAL MASTER CYLINDER

NOTE: Before beginning work,be sure vehicle is parked in a level area and that wheels are chocked to prevent unintentional movement.The master cylinder must be level during the procedure.

1.Disconnect the ground cable from the battery.

2.On manual brake master cylinders(except some Chrysler products),disconnect the push rod from the brake pedal linkage under the dash.The rod eyelet is attached to the pedal with a thru-bolt and cotter pin,nut or retaining clip。

NOTE:Some chrysler vehicles use manual brake master cylinders with a “pop out”pushrod. After removing the flange bolts,support the master cylinder and use a wedge between the flange and firewall to “pop”the pushrod from the piston.Do not separate the pushrod from the brake pedal linkage(see illustration).

3.Disconnect electrical leads from master cylinder's brake failure warning switch,if so equipped.

4.Clean the area around the brake line commections on the master cylinder.

5.Disconnect brake lines from the master cylinder and proportioning valve,if so equipped. Cover or plug lines to prevent dirt from entering and contaminating the brake system.

CAUTION: Do not allow brake fluid to contact painted surfaces as the fluid damages paint. If contact occurs,immediately flood the affected area with water.

6.Remove the nuts/bolts securing the master cylinder to the firewall or power brake booster.Do not remove power brake booster.

7.Remove the master cylinder from the vehicle.CAREFULLY remove and save any fittings,rubber hoses , clamps , plastic , gaskets or other components (including brake warning switches and proportioning valves) for installation on the replacement unit if necessary.

NOTE: If the replacement master cylinder is supplied without a reservoir,you must remove and transfer the reservoir from the original master cylinder to the replacement unit.Refer to the following instructions.

TRANSFERRING THE RESERVOIR

1.Carefully drain remaining brake fluid from the master cylinder.

2.Position the original master cylinder in a vise so the jaws clamp onto the mounting flange. Do not tighten the vise jaws on the master cylinder body! This will cause damage and void the unit's core value.


Contact us if you need more details on Brake Master Cylinder For Toyota Corolla/Matrix. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Brake Master Cylinder For PONTIAC VIBE、19205191 / 47201-02490 / 47201-02491 /47201-12B20. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Brake Master Cylinder